It’s easy to rock your naturally wavy hair most of the time.
You’ll also want to ensure you use the right setting and technique for your straightener.
This takes some prep work.
Straightening works best on clean, just-washed hair.
You’ll want to wash your locks with a high-quality shampoo and conditioner first for the best results.
Let it sit for about an hour before washing it with a mild shampoo and conditioner.
It’s also beneficial to add a heat protectant or hair priming spray.
However, curly-haired individuals need to pre-straighten their hair to get the best results.
Grab your blow dryer, round brush, and clips.
Section off your hair into four to five different parts, and work through one section at a time.
It’s going to straighten and add volume to the roots.
Your hair might look a little wild at this point, but remember, it’s a process.
Once everything is dry, it’s time to section out your hair again.
Therefore, you’ll want to ensure you use the correct setting and start with a clean appliance.
You might not realize it, but hair primer or other products can build up on your flat iron.
To see to it it’s clean before you plug it in, look everything over.
Rub it along the plate to remove any residue so you aren’t adding it to your hair.
With a clean flat iron, it’s time to set the heat.
Straight hair is going to use a lower setting than wavy or curly hair.
When you have fine, straight hair, try 250 degrees.
you’re able to crank it up to 300 if your straight hair is thick or coarse.
Those with wavy to curly hair are going to look for a setting between 300 and 410 degrees.
You’ll want to use the lowest heat possible to achieve the smooth look you want.
Always start at a lower level and increase as needed."
With your prep game on point, it’s time to actually start straightening your hair!
Best technique to flat iron hair
It’s the moment you’ve been waiting for.
Those smooth, luscious locks are about to come to fruition.
It’s essential to start at the bottom and work your way up the hair.
It can be helpful to have a parting comb for getting those perfect sections.
It’s also important to stay about an inch away from the scalp.
The straightener is hot and will definitely burn if it gets too close.
Your hair looks flawless, but you noticed a few stubborn areas that don’t want to cooperate.
Giving that stubborn section of hair another swipe with the iron for that perfectly straight look is also helpful.
You might find that you have a few flyaways after the whole flat ironing process is complete as well.
Just add a bit of the product to a boar bristle brush and comb it through your hair.
This gets the product in there without your hair looking stiff.
